× We have recently moved to a new server. If you run into any issues, please let us know through the Contact Us link at the bottom of the page. Thanks for visiting RocketReviews.

Quest Strobe (RTF)

Quest - Strobe {Kit}

Contributed by Greg Deeter

Construction Rating: starstarstarstar_borderstar_border
Flight Rating: starstarstarstar_borderstar_border
Overall Rating: starstarstarstar_borderstar_border
Manufacturer: Quest
Quest Strobe

Brief:
This is an OOP (Out Of Production) RTF (Ready To Fly) rocket that came with a complete Quest launch kit a few years ago. It included a Quest Launch Pad very similar to an Estes three-footed pad, a nice hand grip controller powered by a 9 Volt battery, wadding, ignitors and 3 Quest B6-4 motors. The motors were so old that the glossy outside paper wrap had come off, so I discarded them by soaking them in water.

Construction:
This kit was nearly RTF (Ready To Fly). While it was a sealed package, I was surprised that it did not have a parachute in the rocket nor in the sealed package. Could that be while it was only on sale for a brief amount of time?

There was not anything to building this rocket, it came done out of the package with no parachute. It does have a higher quality than average Kevlar® to the motor mount recovery system, yet the Kevlar® exceeds the length of the body tube by 4 inches, increasing the chance of a zipper--more so than if it were just short of the body tube allowing only the tubular nylon cord to come into contact with the airframe during recovery. The Kevlar® to the motor mount attached to the 2 foot piece of nylon was nice to see, but it should be at least three times as long.

LaunchFinishing:
This rocket came finished with a red nose cone, purple plastic one piece fin can, and a colored body to meld those two colors together. I personally think that purple and red look awful together.

Construction Rating: 3 out of 5

Flight:
1st flight 8-14-2004 Challenger Club Katy Texas 9am Quest C6-5.

The launch lug on the Strobe is very small and too long as it is molded into the one piece fin can. We had to sand a launch rod down just to get it to fit. First flight was very nice and true and it was recovered about 200 feet from the launch pad. The Quest C6-5 produced a lot more smoke than an Estes C6-5 and the flight looked great

Recovery:
As the package did not come with a chute, I added a 10" nylon chute from Thrustline.

Flight Rating: 3 out of 5

Summary:
Not bad, a good value with the launch pad and motors. Quest had a great starter set here but I hate to think of people launching this with no parachute. Even with the provided B6-4s, no recovery system would be grim.

Overall Rating: 3 out of 5

comment Post a Comment